From

Location

Message

Date Posted

Logan Utah

i am trying to build a pvc frame that is a triangle i want the base to have three connectors that i can connect and one going up the middle so that i can connect a top what angle would i need to do this? i thought a 45 would work but it doesnt quite work any suggestions and where i need to go to get these kind of connectors

2/15/2013 12:50:50 PM

canal winchester ohio

Trust me, if you can't find it here it doesn't exist.
http://pvcfittings.com/

2/15/2013 1:16:15 PM

Mass

US Plastics item # 28225 They are furniture fittings, this was a 3 way elbow I used. they have others

2/15/2013 5:22:19 PM

Germany

Did I get it right that the final construction should look like a tetrahedron? Then you would need something with 60 deg. angle. If I misunderstood, and the final thing should look like a triangular prism, then you need 60 deg. angles for the base and the 90 deg. angle which points upwards.

If you can´t find any of those connectors, grab some chunks of hard wood and drill some holes...and you will be free to decide which angle, which depth and which diameter (it might be easier to find the right size of a drill bit than to find the right size and shape of a PVC connector).

2/15/2013 5:49:28 PM

Mnt.pleasant ,tennessee

You can use a heat gun to bend fitting.just make sure pipe is in 1st.fitting can loose shape

2/19/2013 3:17:20 AM